Not in sync message

Store › Forums › Video Experimenter › Bugs/Problems › Not in sync message

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 23, 2014 at 4:10 pm #681
    kd8txw
    Member

    I get the following message when uploading the Video Frame Capture sketch:
    avrdude: stk500_getsync(): not in sync: resp=0x30

    I have video from my camera on my small TFT color monitor, but I don’t get a captured image overlayed. I try adjusting with the long stem pot. I have Output Select in overlay. I have Sync Select jumper on V input.

    I’m new to Arduino and VE. Any ideas on why I don’t see a captured image?

    Thanks- Gordon

    February 27, 2014 at 1:58 pm #1888
    Michael
    Keymaster

    It sounds like you aren’t even able to put the overlay sketch on the arduino, so that’s why you don’t see the overlay. The error indicates that you have not chosen the correct board or serial port. Check your settings in the Arduino IDE under the Tools menu.

    March 3, 2014 at 7:16 pm #1543
    kd8txw
    Member

    That was it. I had the wrong COM port selected. Thanks

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.