[aldob904]

The SYNC SELECT jumper is in the position V INPUT.

[aldob904]

Hi Michael:

I tried adjusting the small potentiometer but nothing changed.
You said that is my camera “poor timing”, but I used two different cameras, so could you please tell me what camera is required for this board?

[aldob904]

HI Again

I change the camera to a NTSC and now, when switch OUTPUT SELECT to Overlay, now I can see the image from the camera and the text and graphicals from the NTSC example, but the overlay text and graphicals move from left to right very fast.

[aldob904]

hi Michael

camera and Monitor are using PAL system.
Switch “OUTPUT SELECT” :

if I set it as “Overlay” I only see the image from the camera, I don´t see the text or graphicals from the example.
if I set it as “SYNC ONLY” I can see the text and graphics (white on black background) but moving from left to right.

I try using NTSC example but I can see nothing, I used another monitor and the efect is the same, I tried using another Arduino uno and always the same.
I review all components, re-check the solders so I do not what to try now

[Author]

Posts